Two mild steel, sand-molded, extreme bend tow hooks. These are as strong as the originals, which were a factory option in 1972 4x4 trucks and Blazers. These Midwest K5 extreme bend tow hooks are fully functional and virtually unbreakable.
Add on our tow-hook hardware to properly secure these extreme bend tow hooks to your vehicle. This includes:
69-72 Style Tow Hooks Now Available. This style turns opposite of each other unlike the rare extreme bend tow hooks. Offered originally for the 69-72 K Series Trucks. Just as strong as originals. Made in the USA.
Add on our tow-hook hardware to properly secure these tow hooks to your vehicle. This includes:
3M Brand Vinyl Decals cut to match the original design of the 1/2 ton (10") dog dish early style (69-75) hubcaps. This is not a cheap sticker, this is the same high grade vinyl used to wrap the exterior of vehicles then laminated for UV protection. Installation is simple. Clean the surface area, remove the backing, start in the center and work your way out to the outer edges. A heat gun or blow dryer may be required to get that perfect finish. Available as a single set (this will do 1 hubcap) or get a discount when you buy a set of 4 (this will do 4 hubcaps). Vinyl decals must remain flat until installed as vinyl can stretch if folded.
Everything you need to mount your passenger side sport bucket seat for 69-72 K5 Blazer.
Passenger sport seat rear latch assembly is laser cut, zinc plated and tig welded.
Mounting bolts included.
Set up for center location striker which was factory in 71-72.
New front passenger seat upper and lower pivot bracket assemblies.
Upper 13 gauge laser cut pivot brackets paired with laser cut 14 gauge lower pivot brackets. Includes pivot sleeve and black oxide grade 5 bolts. Sold as a pair.
Mounting bolts for floor and seat included.
Exact reproduction of the original passenger rear seat latch striker, 12 gauge steel.
NOTE: Will NOT fit utility bucket seats.**Made In USA**
3M Brand Vinyl Decals cut to match the original design of the 3/4 ton (12") dog dish early style (69-75) hubcaps. This is not a cheap sticker, this is the same high grade vinyl used to wrap the exterior of vehicles then laminated for UV protection. Installation is simple. Clean the surface area, remove the backing, start in the center and work your way out to the outer edges. A heat gun or blow dryer may be required to get that perfect finish. Available as a single set (this will do 1 hubcap) or get a discount when you buy a set of 4 (this will do 4 hubcaps). Vinyl decals must remain flat until installed as vinyl can stretch if folded.